Service Manual

host ip-address Enter the keyword host then the IP address to specify a
host IP address.
dscp Enter this keyword dscp to deny a packet based on the
DSCP value. The range is from 0 to 63.
operator (OPTIONAL) Enter one of the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two
ports for the port command)
port port
Enter the application layer port number. Enter two port
numbers if using the range logical operand. The range is
from 0 to 65535.
destination Enter the IP address of the network or host to which the
packets are sent.
mask Enter a network mask in /prefix format (/x) or A.B.C.D. The
mask, when specified in A.B.C.D format, may be either
contiguous or non-contiguous.
count (OPTIONAL) Enter the keyword count to count packets
processed by the filter.
byte (OPTIONAL) Enter the keyword byte to count bytes
processed by the filter.
order (OPTIONAL) Enter the keyword order to specify the QoS
priority for the ACL entry. The range is from 0 to 254 (where
0 is the highest priority and 254 is the lowest; lower-order
numbers have a higher priority) If you did not use the
keyword order, the ACLs have the lowest order by default
(255).
fragments Enter the keyword fragments to use ACLs to control
packet fragments.
no-drop Enter the keywords no-drop to match only the forwarded
packets.
Defaults Not configured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
246
Access Control Lists (ACL)