Service Manual

Dell(conf)#interface tengigabitethernet 2/23
Dell(conf-if-te-2/23)#dot1x server-timeout 40
dot1x supplicant-timeout
Configure the amount of time after which exchanges with the supplicant time-out.
Syntax
dot1x supplicant-timeout seconds
To return to the default, use the no dot1x supplicant-timeout command.
Parameters
seconds Enter a time-out value in seconds. The range is from 1 to
300, where 300 is implementation dependant. The default is
30.
Defaults 30 seconds
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.6.1.0 Introduced on the C-Series and S-Series.
7.4.1.0 Introduced on the E-Series.
dot1x tx-period
Configure the intervals at which EAPOL PDUs the Authenticator PAE transmits.
Syntax
dot1x tx-period seconds
802.1X
213