Service Manual

vrf vrf-name Enter the keyword vrf followed by the name of the VRF to
view IPv6 VRRP groups corresponding to that VRF.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.10.0 Introduced on the S4810.
8.3.2.0 Introduced on the E-Series TeraScale.
Usage Information The following describes the show vrrp ipv6 command shown in the following
example.
Line Beginning
with
Description
GigabitEthernet... Displays the Interface, the VRRP group ID, and the network
address. If the interface is no sending VRRP packets, 0.0.0.0
appears as the network address.
VRF VRF instance to which the interface (on which the VRRP
group is configured) belongs.
State: master... Displays the interface’s state:
• Na/If (not available).
• master (MASTER virtual router).
• backup (BACKUP virtual router).
the interface’s priority and the IP address of the MASTER.
Hold Down:... This line displays additional VRRP configuration information:
• Hold Down displays the hold down timer interval in
seconds.
• Preempt displays TRUE if preempt is configured and
FALSE if preempt is not configured.
• AdvInt displays the Advertise Interval in seconds.
Adv rcvd:... This line displays counters for the following:
Virtual Router Redundancy Protocol (VRRP)
1885