Service Manual

Parameters
start-delay
number
Enter a start-delay in seconds. The range is from 3 to 100
seconds.
Defaults 3 ccms
Command Modes ETHERNET CFM
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the S-Series.
ping ethernet
Send a loopback message.
Syntax
ping ethernet domain [name l level] ma-name ma-name remote
{dest-mep-id | mac-addr mac-address} source {src-mep-id | port
interface}
Parameters
name | level Enter the domain name or level.
ma-name ma-
name
Enter the keyword ma-name and then enter the
maintenance association name.
dest-mep-id Enter the MEP ID that is the target of the ping.
mac-addr mac-
address
Enter the keyword mac-addr and then enter the MAC
address that is the target of the ping.
src-mep-id Enter the MEP ID that originates the ping.
port interface Enter the keyword port and then enter the interface that
originates the ping.
Defaults none
Command Modes EXEC Privilege
188
802.1ag