Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON

1871

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

9.0.0.0 Introduced on the Z9000.

8.3.19.0 Introduced on the S4820T.

8.3.8.0 Introduced on the S4810.

Usage Information

This command applies to a single interface. When used with the vrrp delay

reload CLI, the later timer rules the VRRP enabling. For example, if vrrp delay

reload

is 600 and the vrrp delay minimum is 300:

• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up

VRRP on all interfaces that are up and configured for VRRP.

• When an interface comes up, whether as part of a system reload or an interface

reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that

interface.

Related Command vrrp delay reload — sets the delay time for VRRP initialization after a system reboot.

vrrp delay reload

Set the delay time for VRRP initialization after a system reboot.

Syntax

vrrp delay reload seconds

Parameters

seconds Enter the number of seconds for the delay. The range is

from 0 to 900 (0 indicates no delay).

Defaults 0

Command Modes INTERFACE

Command History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.