Service Manual

Command History
This guide is platform-specific. For command information about other platforms, see the
relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information The following describes the show vrrp brief command shown in the following example.
Item Description
Interface Lists the interface type, slot, and port that the VRRP group is
configured.
Grp Displays the VRRP group ID.
Pri Displays the priority value assigned to the interface. If you configured
the track command to track that interface and the interface is
disabled, the cost is subtracted from the priority value assigned to the
interface.
Pre States whether preempt is enabled on the interface.
• Y = Preempt is enabled.
• N = Preempt is not enabled.
State Displays the operational state of the interface by using one of the
following:
• NA/IF (the interface is not available).
• MASTER (the interface associated with the MASTER router).
• BACKUP (the interface associated with the BACKUP router).
Master addr Displays the IP address of the MASTER router.
Virtual addr(s) Displays the virtual IP addresses of the VRRP routers associated with
the interface.
1874
Virtual Router Redundancy Protocol (VRRP)