Service Manual

Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the S-Series.
mep cross-check enable
Enable cross-checking.
Syntax
mep cross-check enable {port | vlan-id}
Parameters
port Down service with no VLAN association.
vlan-id Enter the VLAN to apply the cross-check.
Defaults none
Command Modes ECFM DOMAIN
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Introduced on the S-Series.
mep cross-check start-delay
Configure the amount of time the system waits for a remote MEP to come up before the cross-check
operation is started.
Syntax
mep cross-check start-delay number
802.1ag
187