Service Manual

Command Modes VLT DOMAIN

Command History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.5(0.1) Introduced on the Z9500.

9.2(0.0) Introduced on the M I/O Aggregator. This command is

supported in Programmable-Mux (PMUX) mode only.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.8.0 Introduced on the S4810.

Usage Information After you configure the VLT domain on each peer switch on both sides of the

interconnect trunk, by default, the Dell Networking OS software elects a primary

and secondary VLT peer device. To reconfigure the primary role of VLT peer

switches, use the priority command.

show vlt brief

Displays summarized status information about VLT domains currently configured on the switch.

Syntax

show vlt brief

Default Not configured.

Command Modes EXEC