Service Manual

vlan-stack compatible
Enable the stackable VLAN feature on a VLAN.
Syntax
vlan-stack compatible
To disable the Stackable VLAN feature on a VLAN, use the no vlan-stack
compatible command.
Defaults Not configured.
Command Modes CONF-IF-VLAN
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the C-Series and S-Series.
E-Series original
Command
Usage Information
Prior to disabling the stackable VLAN feature, remove the members.
To view the stackable VLANs, use the show vlan command in EXEC Privilege
mode. Stackable VLANs contain members, designated by the M in the Q column of
the command output.
If VRF is enabled, then you cannot enable the stacked VLAN feature using this
command.
If IGMP snooping is enabled, then you cannot enable the stacked VLAN feature
using this command.
Example
Dell#show vlan
Codes: * - Default VLAN, G - GVRP VLANs
NUM Status Q Ports
* 1 Inactive
VLAN Stacking
1803