Service Manual

Uplink State Group : 7 Status: Enabled, Up
Upstream Interfaces :
Downstream Interfaces :
Uplink State Group : 16 Status: Disabled, Up
Upstream Interfaces : Te 1/25(Dwn) Po 8(Dwn)
Downstream Interfaces : Te 1/30(Dwn)
Related
Commands
• show running-config uplink-state-group — displays the current configuration
of one or more uplink-state groups.
• uplink-state-group — create an uplink-state group and enables the tracking of
upstream links.
uplink-state-group
Create an uplink-state group and enable the tracking of upstream links on a switch/ router.
Syntax
uplink-state-group group-id
To delete an uplink-state group, enter the no uplink-state-group group-id
command.
Parameters
group-id Enter the ID number of an uplink-state group. The range is
from 1 to 16.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.4.2.3 Introduced on the S-Series S50.
Usage Information
After you enter the command, to assign upstream and downstream interfaces to
the group, enter Uplink-State-Group Configuration mode.
1794
Uplink Failure Detection (UFD)