Service Manual

Parameters
vrf vrf-name (Optional) Enter the keyword vrf and then the name of the
VRF to configure a NTP time-serving host corresponding to
that VRF.
ipv4-address |
ipv6-address
Enter an IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X)
of NTP server.
hostname Enter the hostname of the server.
key keyid (OPTIONAL) Enter the keyword key and a number as the
NTP peer key. The range is from 1 to 4294967295.
prefer (OPTIONAL) Enter the keyword prefer to indicate that this
peer has priority over other servers.
version number (OPTIONAL) Enter the keyword version and a number to
correspond to the NTP version used on the server. The
range is from 1 to 4.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.6(0.0) Added support for VRF.
9.4.(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.4.1.0 Added IPv6 support.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information
You can configure multiple time-serving hosts . From these time-serving hosts, the
Dell Networking OS chooses one NTP host with which to synchronize. To
determine which server was selected, use the show ntp associations
command.
1768
System Time and Date