Service Manual

stack-unit provision
Preconfigure a logical stacking ID of a switch that joins the stack. This is an optional command that is
executed on the management unit.
Syntax
stack-unit [stack-number] provision {S4810|S4820T|S6000|Z9000}
Parameters
stack-unit Enter a stack member identifier of the switch that you want
to add to the stack.
S4810|S4820T|
S6000|Z9000
Enter the model identifier of the switch to be added as a
stack member. This identifier is also referred to as the
provision type.
Defaults When this value is not set, a switch joining the stack is given the next available
sequential stack member identifier.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
Related
Commands
• reload – reboots Dell Networking OS.
• show system (S-Series and Z-Series) – displays the status of all stack members
or a specific member.
stack-unit stack-group
Configure the stacking unit and stacking group by specifying an ID when adding units to a stack to ensure
the unit is assigned to the correct group.
Syntax
stack-unit unit-id stack-group stack-group-id
To remove the current stack group configuration, use the no stack-unit unit-
id stack-group stack-id command.
Stacking
1729