Service Manual

Parameters

vrf vrf-name Enter the keyword vrf and then the name of the VRF to

associate an SNMP agent with that VRF.

Defaults Not Enabled.

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.4(0.0) Introduced on the S-Series and Z9000.

Usage Information

Use this command to bind an SNMP agent to a VRF. The SNMP agent processes

the requests from the interfaces that belong to the specified VRF. If no VRF is

specified, then the default VRF is used.

Commands

show snmp user — displays the information configured on each SNMP user name.

snmp trap link-status

Enable the interface to send SNMP link traps, which indicate whether the interface is up or down.

Syntax

snmp trap link-status

To disable sending link trap messages, use the no snmp trap link-status

command.

Defaults Enabled.

Command Modes INTERFACE