Service Manual

Usage Information This command changes the sampling rate for an interface. By default, the sampling
rate of an interface is set to the same value as the current global default sampling
rate. If the value entered is not a correct power of 2, the command generates an
error message with the previous and next power-of-2 value. Select one of these
two number and re-enter the command.
Related
Commands
sflow sample-rate (Global) — changes the sampling rate globally.
show sflow
Display the current sFlow configuration.
Syntax
show sflow [interface]
Parameters
interface (OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For the Management interface on the stack-unit, enter
the keyword ManagementEthernet then the slot/port
information.
The slot range is from 1 to 11. The port
range is 1.
• For a port channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 100/1000 Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
1664
sFlow