Service Manual

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.4.1.0 Introduced

Usage Information Dell Networking OS must have the default CAM profile with the default microcode

before you enable L2PT.

protocol-tunnel rate-limit

Enable traffic rate limiting per box.

Syntax

protocol-tunnel rate-limit rate

To reset the rate limit to the default, use the no protocol-tunnel rate-limit

rate command.

Parameters

rate Enter the rate in frames per second. The range is from 75 to

3000. The default is 75.

Defaults 75 frames per second.

Command Modes CONF-IF-VLAN-STACK

Command History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.