Service Manual

-p port-number (OPTIONAL) Enter the keyword -p then the port number.
The range is from 1 to 65535. The default is 22.
-v {1 | 2} (OPTIONAL) Enter the keyword -v then the SSH version 1 or
2. The default is the version from the protocol negotiation.
Defaults As shown in the Parameters section.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.4.(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.12.0 Added support for the -c and -m parameters on the S4810.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Added IPv6 support. Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information Dell Networking OS supports both inbound and outbound SSH sessions using IPv4
or IPv6 addressing. Inbound SSH supports accessing the system through the
management interface as well as through a physical Layer 3 interface.
Example
Dell#ssh 10.16.151.48 -l anvltest
Trying 10.16.151.48...
01:18:16: %STKUNIT0-M:CP %SEC-5-SSH_USAGE: Initiated SSH
Client v2 (FIPS Disabled) to anvltest@10.16.151.48 by default
from console
anvltest@10.16.151.48's password:
Last login: Thu Jan 5 00:17:47 2012 from login-maa-101
[anvltest@dt-maa-linux-1 ~]# exit
logout
Dell#
Security
1633