Service Manual

• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-
channel
then a number. The range is from 1 to 128.
• For a Null interface, enter the keyword null then the Null
interface number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.4(0.0) Introduced on the S-Series and Z9000.
Usage Information
The source-interface interface attribute is applicable for both the SSH
client as well as the COPY (SCP) commands. Using these attributes the client
session tags an error to the user during run time, in case there is a mismatch
between this command and the
ip ssh vrf command.
Example
Dell(conf)#ip ssh source-interface tengigabitethernet 1/42
Dell(conf)#do ssh 10.10.10.2 -l admin
Dell(conf)#no ip ssh source-interface
ip ssh vrf
Specify a VRF for an outgoing SSH connections.
Syntax
ip ssh vrf vrf-name
To delete a VRF for an outgoing SSH connection, use the no ip ssh vrf vrf-
name command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to
configure that VRF for an outgoing SSH session.
Defaults Not configured.
Command Modes CONFIGURATION
1626
Security