Service Manual

Usage Information RIP supports a maximum of 16 ECMP paths.
neighbor
Define a neighbor router with which to exchange RIP information.
S4048–ON
Syntax
neighbor ip-address
To delete a neighbor setting, use the no neighbor ip-address command.
Parameters
ip-address Enter the IP address, in dotted decimal format, of a router
with which to exchange information.
Defaults Not configured.
Command Modes ROUTER RIP
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.6.1.0 Introduced on the C-Series.
pre- 6.2.1.1 Introduced on the E-Series.
Usage Information
When a neighbor router is identified, unicast data exchanges occur. Multiple
neighbor routers are possible.
To ensure that only specific interfaces are receiving and sending data, use the
passive-interface command with the neighbor command.
Related
Commands
passive-interface — sets the interface to only listen to RIP broadcasts.
Routing Information Protocol (RIP)
1501