Service Manual

Version Description
pre- 6.2.1.1 Introduced on the E-Series.
Related
Commands
ip prefix-list — enters PREFIX-LIST mode and configures a prefix list.
distribute-list out
Configure a filter for outgoing routing updates.
S4048–ON
Syntax
distribute-list prefix-list-name out [interface | bgp |
connected | isis |ospf | static]
To delete the filter, use the no distribute-list prefix-list-name out
command.
Parameters
prefix-list-name Enter the name of a configured prefix list.
interface (OPTIONAL) Identifies the interface type slot/port as one of
the following:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number
from 1 to 4094.
connected (OPTIONAL) Enter the keyword connected to filter only
directly connected routes.
isis (OPTIONAL) Enter the keyword isis to filter only IS-IS
routes.
ospf (OPTIONAL) Enter the keyword ospf to filter all OSPF
routes.
static (OPTIONAL) Enter the keyword static to filter manually
configured routes.
Defaults Not configured.
Command Modes ROUTER RIP
Routing Information Protocol (RIP)
1495