Service Manual

Defaults none
Command Modes CONFIGURATION (config-wred)
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
Usage Information To configure the minimum and maximum threshold values for user-defined
profiles, use this command. Additionally, to modify the minimum and maximum
threshold values for the pre-defined WRED profiles, use this command. If you
delete the threshold values of the pre-defined WRED profiles, the profiles revert to
their original default values.
Pre-Defined WRED
Profile Name
Minimum
Threshold
Maximum
Threshold
wred_drop 0 0
100
wred_ten_y 467 4671 100
wred_ten_g 467 4671 50
wred_fortyg_y 467 4671 50
wred_fortyg_g 467 4671 25
Related
Commands
wred-profile — creates a WRED profile.
trust
Specify dynamic classification (DSCP) or dot1p to trust.
S4048–ON
Syntax
trust {diffserv [fallback]| dot1p [fallback]}
Parameters
diffserv Enter the keyword diffserv to specify trust of DSCP
markings.
1476
Quality of Service (QoS)