Service Manual

Field Description
Status (Allowed
ports)
Indicates if the input policy map configuration on an
interface belonging to a stack-unit/port-pipe is successful
— Allowed (n) — or not successful — Exception. The
allowed number (n) indicates the number of ports in that
port-pipe on which the Policy Map can be applied
successfully.
NOTE: In a Layer 2 Policy Map, IPv4/IPv6 rules are not allowed; therefore, the
output contains only L2ACL CAM partition entries.
Example
Dell# test cam-usage service-policy input pmap_l2 stack-unit
all
For a L2 Input Policy Map pmap_l2, the output must be as
follows,
stack-unit|Portpipe|CAM Partition|Available CAM|Estimated CAM|
Status
| | | |per Port |
(Allowed ports)
0 0 L2ACL 500 200
Allowed (2)
0 1 L2ACL 100 200
Exception
1 0 L2ACL 1000 200
Allowed (5)
1 1 L2ACL 0 200
Exception
…
…
…
13 1 L2ACL 400 200
Allowed (2)
Dell#
threshold
Specify the minimum and maximum threshold values for the configured WRED profiles.
S4048–ON
Syntax
threshold min number max number max-drop-probability
To remove the threshold values, use the no threshold min number max
number command.
Parameters
min number Enter the keyword min then the minimum threshold
number for the WRED profile. The range is from 1 to 9360.
max-drop-
probability
number
Enter the keyword max-drop-probability followed by the
maximum number of packets for the WRED profile. The
range is from 0 to 100 KB
Quality of Service (QoS)
1475