Service Manual

qos-policy-output
Create a QoS output policy.
S4048–ON
Syntax
qos-policy-output qos-policy-name
To remove an existing output QoS policy, use the no qos-policy-output qos-
policy-name command.
Parameters
qos-policy-name Enter your output QoS policy name in character format (32
characters maximum).
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information
Use this command to specify the name of the output QoS policy. Once output
policy is specified, rate-shape, scheduler strict, bandwidth-percentage, and WRED
can be defined. This command enables the qos-policy-output configuration mode
—(conf-qos-policy-out).
Related
Commands
bandwidth-percentage — assigns percentage of bandwidth to the class/queue.
wred — assigns yellow or green drop precedence.
1456
Quality of Service (QoS)