Service Manual

Commands

class-map — identifies the class map.

policy-aggregate

Allow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is part

of the policy map (output) applied on an interface.

S4048–ON

Syntax

policy-aggregate qos-policy-name

To remove a policy aggregate configuration, use the no policy-aggregate

qos-policy-name command.

Parameters

qos-policy-name Enter the name of the policy map in character format (32

characters maximum).

Defaults none

Command Modes CONFIGURATION (policy-map-input and policy-map-output)

Command History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

Usage Information If the rate shape exists in both aggregate and per-queue qos-policy, minimum of 2

take effect. Some of all Queue-rate will not exceed aggregate.

Commands

policy-map-input — creates an input policy map.

policy-map-output — creates an output policy map.

1452

Quality of Service (QoS)