Service Manual

Related
Commands
class-map — identifies the class map.
match ip vrf
Uses a VRF as the match criterion for an L3 class map.
S4048–ON
Syntax
match ip vrf vrf-id
To remove VRF as the match criterion, use the no match ip vrf vrf-id
command.
Parameters
vlan vlan-id Enter the keyword vrf and then the ID of the VRF. The
range is from 1 to 63.
Defaults none
Command Modes CONF-CLASS-MAP
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5.(0.0) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z-Series.
Usage Information To access this command, enter the class-map command. After the class map is
identified, you can configure the match criteria.
Use this command to match an IP class-map against a single VRF ID .
Related
Commands
class-map — identifies the class map.
match mac access-group
Configure a match criterion for a class map, based on the contents of the designated MAC ACL.
S4048–ON
Syntax
match mac access-group {mac-acl-name}
Quality of Service (QoS)
1449