Service Manual

match ip precedence
Use IP precedence values as a match criteria.
S4048–ON
Syntax
match {ip | ipv6 | ip-any} precedence ip-precedence-list [set-
ip-dscp value]
To remove IP precedence as a match criteria, use the no match {ip | ipv6 |
ip-any} precedence ip-precedence-list [[multicast] set-ip-dscp
value] command.
Parameters
ip Enter the keyword ip to support IPv4 traffic.
ipv6 Enter the keyword ipv6 to support IPv6 traffic.
ip-any Enter the keyword ip-any to support IPv4 and IPv6 traffic.
ip-precedence-
list
Enter the IP precedence value(s) as the match criteria.
Separate values by commas — no spaces ( 1,2,3 ) or indicate
a list of values separated by a hyphen (1-3). The range is
from 0 to 7.
set-ip-dscp value (OPTIONAL) Enter the keywords set-ip-dscp then the IP
DSCP value. The matched traffic is marked with the DSCP
value. The range is from 0 to 63.
Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Added support for the ipv6 and ip-any options on the
Z9000, S6000, S4820T, S4810, MXL.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Quality of Service (QoS)
1447