Service Manual

a list of values separated by a hyphen (1-3). The range is
from 0 to 63.
set-ip-dscp value (OPTIONAL) Enter the keywords set-ip-dscp then the IP
DSCP value. The matched traffic is marked with the DSCP
value. The range is from 0 to 63.
Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Added the ipv6 and ip-any options on the Z9000, S6000,
S4820T, S4810, MXL.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
Usage Information
To access this command, enter the class-map command. After the class map is
identified, you can configure the match criteria.
The match ip dscp and match ip precedence commands are mutually
exclusive.
Up to 64 IP DSCP values can be matched in one match statement. For example, to
indicate IP DCSP values 0 1 2 3 4 5 6 7, enter either the match ip dscp
0,1,2,3,4,5,6,7 or match ip dscp 0-7 command.
NOTE: Only one of the IP DSCP values must be a successful match criterion,
not all of the specified IP DSCP values must match.
Related
Commands
class-map — identifies the class map.
1446
Quality of Service (QoS)