Service Manual

set-color value (Optional) Enter the keyword set-color followed by a color

value. Traffic that fulfills the match criteria is marked with

the color value that you specify. The default value is Yellow.

Defaults none

Command Modes CLASS-MAP CONFIGURATION (config-class-map)

Command History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

Usage Information To access this command, enter the class-map command. After the class map is

identified, you can configure the match criteria. For class-map match-any, a

maximum of five ACL match criteria are allowed. For class-map match-all,

only one ACL match criteria is allowed.

Commands

class-map — identifies the class map.

match ip dscp

Use a differentiated services code point (DSCP) value as a match criteria.

S4048–ON

Syntax

match {ip | ipv6 | ip-any} dscp dscp-list [set-ip-dscp value]

To remove a DSCP value as a match criteria, use the no match {ip | ipv6 |

ip-any} dscp dscp-list [[multicast] set-ip-dscp value] command.

Parameters

ip Enter the keyword ip to support IPv4 traffic.

ipv6 Enter the keyword ipv6 to support IPv6 traffic.

ip-any Enter the keyword ip-any to support IPv4 and IPv6 traffic.

dscp-list Enter the IP DSCP values that is to be the match criteria.

Separate values by commas — no spaces ( 1,2,3 ) or indicate

Quality of Service (QoS)

1445