Service Manual

Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series ExaScale.
7.7.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage Information The monitoring command is saved in the running configuration at the Monitor
Session mode level and can be restored after a chassis reload.
Example
Dell# show running-config monitor session
!
monitor session 1
source TenGigabitEthernet 1/1 destination TenGigabitEthernet
1/2 direction rx
!
monitor multicast-queue 7
Related
Commands
monitor session — creates a monitoring session.
show monitor session — displays a monitoring session.
source (port monitoring)
Configure a port monitor source.
Syntax
source {interface | range | any} destination interface
direction {rx | tx | both}
To disable a monitor source, use the no source interface destination
interface direction {rx | tx | both} command.
1406
Port Monitoring