Service Manual

rate-limit
Configure the rate-limit to limit the mirrored packets.
Syntax
rate-limit limit
To remove the limit, use the no rate-limit limit command.
Parameters
limit Enter the rate-limit value. The range is from 0 to 40000
Megabits per second.
Defaults 60
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S4810, S4820T, S5000, S6000, S6000-
ON, Z9500, S3048-ON and S4048-ON.
Related
Commands
monitor session — enables a monitoring session.
show monitor session — displays the monitor session.
show config
Display the current monitor session configuration.
Syntax
show config
Defaults none
Command Modes MONITOR SESSION (conf-mon-sess-session-ID)
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048–ON and S4048–ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
Port Monitoring
1403