Service Manual

Command History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.1.(0.0) Introduced on the S4810 and Z9000.

7.8.1.0 Added support for the C-Series.

7.4.1.0 Introduced on the E-Series.

8.3.19.0 Introduced on the S4820T.

Usage Information

The time interval between hello packets must be the same for routers in a network.

Commands

ipv6 ospf dead-interval – specifies the time interval between hello packets was

received from a router.

ipv6 ospf priority

To determine the Designated Router for the OSPFv3 network, set the priority of the interface.

Syntax

ipv6 ospf priority number

To return to the default time interval, use the no ipv6 ospf priority

command.

Parameters

number

Enter the number as the priority. The range is from 1 to 255.

Defaults 1

Command Modes INTERFACE