Service Manual

show ip ospf interface — displays the OSPF interfaces configured.
show ip ospf neighbor — displays the OSPF neighbors configured.
show ip ospf asbr
Display all autonomous system boundary router (ASBR) routers visible to OSPF.
S4048–ON
Syntax
show ip ospf [process-id | vrf vrf-name] asbr
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support of Multi-Process OSPF.
7.8.1.0 Added the process-id option, in support of Multi-Process
OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series and E-Series.
Usage Information To isolate problems with external routes, use this command. In OSPF, external
routes are calculated by adding the LSA cost to the cost of reaching the ASBR
router. If an external route does not have the correct cost, use this command to
determine if the path to the originating router is correct. The display output is not
sorted in any order.
Open Shortest Path First (OSPFv2 and OSPFv3)
1283