Service Manual

Command History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.0.2.0 Introduced on the S6000.

9.1(0.0) Added support for OSPFv3 on the S4810 and Z9000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Added support for Multi-Process OSPF.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

pre- 6.1.1.1 Introduced on the E-Series.

Usage Information You must have an IP address assigned to an interface to enter ROUTER OSPF mode

and configure OSPF.

Example

Dell(conf)#router ospf 2

Dell(conf-router_ospf)#

show config

Display the non-default values in the current OSPF configuration.

S4048–ON

Syntax