Service Manual

Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to
specify the VRF that is used by the TFTP client.
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.4.(0.0) Introduced on the S-Series and Z9000.
Usage Information Use this command to make the TFTP clients VRF aware. The VRF name that you
specify is used by the TFTP client to reach the TFTP server. If no VRF is specified,
then the default VRF is used.
Related
Commands
ftp-server topdir — sets the directory to be used for incoming FTP connections.
ftp-server username — sets a username and password for incoming FTP
connections.
line
Enable and configure console and virtual terminal lines to the system. This command accesses LINE
mode, where you can set the access conditions for the designated line.
Syntax
line {aux 0 |console 0 | vty number [end-number]}
Parameters
aux 0 Enter the keyword aux 0 to configure the auxiliary terminal
connection.
console 0 Enter the keyword console 0 to configure the console
port. The console option for the S-Series is <0-0>.
vty number Enter the keyword vty then a number from 0 to 9 to
configure a virtual terminal line for remote sessions. The
system supports 10 remote sessions.
126
Control and Monitoring