Service Manual

IPv6 Object Tracking Commands
The following section describes the IPv6 object tracking commands.
The following object tracking commands apply to IPv4 and IPv6:
• debug track
• delay
• description
• show running-config track
• threshold metric
• track interface line-protocol
show track ipv6 route
Display information about all tracked IPv6 routes, including configuration, current tracked state (UP or
DOWN), and the clients which are tracking an object.
Syntax
show track ipv6 route [brief]
Parameters
brief (OPTIONAL) Display a single line summary of information
for tracked IPv6 routes.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Usage Information The following describes the show track ipv6 route command shown in the
Example below.
Output Description
Track object-id Displays the number of the tracked object.
Interface type
slot/port, IP route
ip-address, IPv6
route ipv6-
address
Displays the interface type and slot/port number or address
of the IPv4/IPv6 route that is being tracked.
object is Up/
Down
Up/Down state of tracked object; for example, IPv4
interface, reachability or metric threshold of an IP route.
Object Tracking
1231