Service Manual

show config
Display the RA guard policy mode configurations.
Syntax
show config
Command Modes POLICY LIST CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and
Z9000 switches.
Example
Dell(conf)#ipv6 nd ra-guard policy test
Dell(conf-ra_guard_policy_list)#show config
!
ipv6 nd ra-guard policy test
device-role router
hop-limit maximum 251
mtu 1350
other-config-flag on
reachable-time 540
retrans-timer 101
router-preference maximum medium
trusted-port
Dell(conf-ra_guard_policy_list)#
Related
Commands
• ipv6 nd ra-guard enable — Allows you to configure the RA guard related
commands.
• ipv6 nd ra-guard policy — Defines the RA guard policy name and enter the RA
guard policy list configuration mode.
• device-role — Specifies the role of the device attached to the port.
• hop-limit — Enables the verification of the advertised hop count limit.
• mtu — Sets the maximum transmission unit (MTU) value.
• other-config-flag — Enables the verification of the advertised other
configuration parameter.
• reachable-time — Sets the advertised reachability time.
• retrans-timer — Sets the advertised retransmission time.
• router-preference maximum — Enables the verification of the advertised default
router preference (DRP) value.
• trusted-port — Applies the policy to trusted ports.
1214
Neighbor Discovery Protocol (NDP)