Service Manual

retrans-time
Enable the verification of the configured retransmission timer value in the received RA packets.
Syntax
retrans—timer value
To reset the advertised retransmission interval, use the no retrans-timervalue
command.
Parameters
value Enter the advertised retransmission time interval in
milliseconds. The range is from 100 to 4,294,967,295
milliseconds.
Defaults none
Command Modes POLICY LIST CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and
Z9000 switches.
Related
Commands
ipv6 nd raguard policy policy-name — Defines the router advertisement (RA) guard
policy name and enter the RA guard policy configuration mode.
router-lifetime
Set the router lifetime.
Syntax
router—lifetime value
Parameters
value Enter the router lifetime in seconds. The range is from 0 to
9,000 seconds.
Defaults none
Command Modes POLICY LIST CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
1212
Neighbor Discovery Protocol (NDP)