Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON

1201

To reset the MTU value, use the no mtu value command.

Parameters

value Enter the maximum transmission unit value in bytes. The

range is from 1,280 to 11,982 bytes.

Defaults 0

Command Modes POLICY LIST CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms,

refer to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Version Description

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.7(0.0) Introduced on the S4810, S4820T, S5000, S6000, and

Z9000 switches.

Commands

• ipv6 nd ra-guard enable — Allows you to configure the RA guard related

commands.

• ipv6 nd raguard policy policy-name — Defines the RA guard policy name and

enter the RA guard policy configuration mode.

other-config-flag

Enable the verification of the advertised other configuration parameter. If this command is not

configured, the verification process is bypassed.

Syntax

other-config-flag {on | off}

To reset the other configuration parameter, use the no other-config-flag

{on | off} command.

Parameters

on Enter the keyword on to set the other-config-flag value as

ON.

off Enter the keyword off to set the other-config flag value as

OFF.

Defaults none