Service Manual

show ipv6 neighbors
Display IPv6 discovery information. Entering the command without options shows all IPv6 neighbor
addresses stored on the control processor (CP).
Syntax
show ipv6 neighbors [vrf vrf-name] [ipv6-address| interface interface]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to display the neighbors corresponding to that VRF.
NOTE: If you do not specify this option, neighbors corresponding to the default VRF are displayed.
ipv6-address Enter the IPv6 address of the neighbor in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zero.
interface interface Enter the keyword interface then the interface type and slot/port or number information:
• For a port channel interface, enter the keywords port-channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line
Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
Example
Dell# show ipv6 neighbors
IPv6 Address Expires(min) Hardware Address State Interface VLAN CPU
--------------------------------------------------------------------------------------------------------------
Neighbor Discovery Protocol (NDP)
1203