Service Manual

tc-flush-standard
Enable the MAC address flushing after receiving every topology change notification.
Syntax
tc-flush-standard
To disable, use the no tc-flush-standard command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.5.1.0 Introduced
Usage Information By default, Dell Networking OS implements an optimized flush mechanism for
MSTP. This mechanism helps in flushing the MAC addresses only when necessary
(and less often) allowing for faster convergence during topology changes.
However, if a standards-based flush mechanism is needed, this knob command
can be turned on to enable flushing MAC addresses after receiving every topology
change notification.
1190
Multiple Spanning Tree Protocol (MSTP)