Service Manual

ip msdp sa-limit
Configure the upper limit of source-active (SA) entries in SA-cache.
Syntax
ip msdp sa-limit number
To return to the default, use the no ip msdp sa-limit number command.
Parameters
number Enter the maximum number of SA entries in SA-cache. The
range is from 1 to 500000.
Defaults 50000
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.5.1.0 Introduced on the E-Series.
Usage Information Dell Networking OS counts the SA messages originated by itself and those
messages received from the MSDP peers. When the total SA messages reach this
limit, the subsequent SA messages are dropped (even if they pass RPF checking and
policy checking).
If the total number of SA messages is already larger than the limit when this
command is applied, those SA messages that are already in Dell Networking OS
continue to be accepted. To enforce the limit in such situation, use the clear ip
msdp sa-cache command.
Related
Commands
ip msdp peer — configures the MSDP peer.
clear ip msdp peer — clears the MSDP peer.
show ip msdp — displays the MSDP information.
Multicast Source Discovery Protocol (MSDP)
1169