Service Manual

description name (OPTIONAL) Enter the keyword description then a
description name (maximum 80 characters) to designate a
description for the MSDP peer.
sa-limit number (OPTIONAL) Enter the maximum number of SA entries in
SA-cache. The range is from 1 to 100000. .
Defaults As described in the Parameters section.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
7.5.1.0 Added option for SA upper limit and the description
option.
6.2.1.1 Introduced
Usage Information
The connect-source option is used to supply a source IP address for the TCP
connection. When an interface is specified using the connect-source option, the
primary configured address on the interface is used.
If the total number of SA messages received from the peer is already larger than the
limit when this command is applied, those SA messages continue to be accepted.
To enforce the limit in such situation, use the clear ip msdp peer command to
reset the peer.
Related
Commands
ip msdp sa-limit — configures the MSDP SA Limit.
clear ip msdp peer — clears the MSDP peer.
show ip msdp — displays the MSDP information.
1166
Multicast Source Discovery Protocol (MSDP)