Service Manual

To clear the MSDP rejected source-active entries, use the no ip msdp cache-
rejected-sa {number} command then the ip msdp cache-rejected-sa
{
number} command.
Parameters
number Enter the number of rejected SA entries to cache. The range
is from 0 to 32766.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.4.1.0 Introduced
Related
Commands
show ip msdp sa-cache rejected-sa — displays the rejected SAs in the SA cache.
ip msdp default-peer
Define a default peer from which to accept all source-active (SA) messages.
Syntax
ip msdp default-peer peer address [list name]
To remove the default peer, use the no ip msdp default-peer {peer
address} list name command.
Parameters
peer address Enter the peer address in a dotted decimal format (A.B.C.D.)
list name Enter the keywords list name and specify a standard
access list that contains the RP address that should be
Multicast Source Discovery Protocol (MSDP)
1161