Service Manual

32
Link Aggregation Control Protocol (LACP)
This chapter contains commands for Dell Networks’s implementation of the link aggregation control
protocol (LACP) for creating dynamic link aggregation groups (LAGs) — known as “port-channels” in the
Dell Networking operating software. The LACP commands in this chapter are supported by Dell
Networking OS on the S4048–ON platform.
NOTE: For static LAG commands, refer to Port Channel Commands in the Interfaces chapter),
based on the standards specified in the IEEE 802.3 Carrier sense multiple access with collision
detection (CSMA/CD) access method and physical layer specifications.
clear lacp counters
Clear port channel counters.
Syntax
clear lacp port-channel-number counters
Parameters
port-channel-
number
Enter a port-channel number. The range is from 1 to 128.
Defaults Without a Port Channel specified, the command clears all Port Channel counters.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048–ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
1076
Link Aggregation Control Protocol (LACP)