Service Manual

updates tied to the VRF that you specify. This command
displays the local LSP debugging details of the current unit.
interface (OPTIONAL) Identifies the interface type slot/port[/subport]
as one of the following:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port[/subport]
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port channel interface, enter the keywords port-
channel then a number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.2(0.2) Introduced on the Z9000.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
6.3.1.0 Introduced.
debug isis snp-packets
To debug IS-IS complete sequence number PDU (CSNP) and partial sequence number PDU (PSNP)
packets, enable debugging on a specific interface and provides diagnostic information.
Syntax
debug isis [vrf vrf-name] snp-packets [interface]
To turn off debugging, use the no debug isis [vrf vrf-name] snp-
packets [interface] command.
1012
Intermediate System to Intermediate System (IS-IS)