Service Manual

cam-acl-vlan
Specify the number of VFP blocks allocated to OpenFlow.
Syntax
cam-acl-vlan vlanopenflow {0|1}
Defaults Disabled.
Parameters
vlanopenflow Enter the number 1 to allocate VFP blocks and enable
OpenFlow.
(Default) Enter the number 0 to disable OpenFlow.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.1.(0.0) Introduced on S4810.
8.3.19.0 Introduced on the S4820T.
Usage Information
Reboot the switch after changing the parameter values for changes to take effect.
For platform-specific instructions about using this command, refer to the SDN
chapter in the Dell Networking OS Configuration Guide.
clear line
Reset a terminal line.
Syntax
clear line {line-number | console 0 | vty number}
Parameters
line-number Enter a number for one of the 12 terminal lines on the
system. The range is from 0 to 11.
aux 0 Enter the keywords aux 0 to reset the auxiliary port.
console 0 Enter the keywords console 0 to reset the console port.
vty number Enter the keyword vty then a number to clear a terminal
line. The range is from 0 to 9.
Control and Monitoring
101