Administrator Guide

DCBX Commands
The following DCBX commands are supported on the Dell EMC Networking OS.
advertise dcbx-app-tlv
Configure DCBX to send iSCSI TLV advertisements.
Syntax
advertise dcbx-app-tlv iscsi
To disable DCBX iSCSI TLV advertisements, use the no advertise dcbx-app-tlv iscsi command.
Defaults Enabled
Command Modes PROTOCOL LLDP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module.
Usage Information You can configure iSCSI TLVs to send either globally or on a specified interface. The interface configuration takes
priority over global configuration.
advertise dcbx-appln-tlv
On a DCBX port with a manual role, configure the application priority TLVs advertised on the interface to DCBX peers.
Syntax
advertise dcbx-appln-tlv {fcoe | iscsi}
To remove the application priority TLVs, use the no advertise dcbx-appln-tlv {fcoe | iscsi}
command.
Parameters
{fcoe | iscsi} Enter the application priority TLVs, where:
• fcoe: enables the advertisement of FCoE in application priority TLVs.
• iscsi: enables the advertisement of iSCSI in application priority TLVs.
Defaults Application priority TLVs are enabled to advertise FCoE and iSCSI.
Command Modes PROTOCOL LLDP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
496 Data Center Bridging (DCB)