Service Manual

– For a Loopback interface, enter the keyword loopback then a number from 0 to 16383.
– For the Management interface on the stack-unit, enter the keyword ManagementEthernet then
the slot/port information.
The slot range is from 1 to 11. The port range is 1.
– For a port channel interface, enter the keywords port-channel then a number.
– For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
– (OPTIONAL) To clear statistics for all VRRP groups configured, enter the keyword vrrp. Enter a
number from 1 to 255 as the vrid.
– (OPTIONAL) To clear unknown source address (SA) drop counters when you configure the MAC
learning limit on the interface, enter the keywords learning-limit.
Example of the clear counters Command
When you enter this command, confirm that you want Dell Networking OS to clear the interface counters
for that interface.
Dell#clear counters te 1/1
Clear counters on TenGigabitEthernet 1/1 [confirm]
Dell#
Enhanced Validation of Interface Ranges
This functionality is supported on the platform.
You can avoid specifying spaces between the range of interfaces, separated by commas, that you
configure by using the interface range command. For example, if you enter a list of interface ranges,
such as
interface range fo 2/50-2,te 1/1, this configuration is considered valid. The comma-
separated list is not required to be separated by spaces in between the ranges. You can associate
multicast MAC or hardware addresses to an interface range and VLANs by using the mac-address-
table static multicast-mac-address vlan vlan-id output-range interface command.
Interfaces
457