Service Manual

!
interface Port-channel 20
no ip address
switchport
vlan-stack trunk
vlt-peer-lag port-channel 20
no shutdown
Dell#
Configure the VLAN as VLAN-Stack VLAN and add the VLT LAG as members to the VLAN
Dell(conf)#interface vlan 50
Dell(conf-if-vl-50)#vlan-stack compatible
Dell(conf-if-vl-50-stack)#member port-channel 10
Dell(conf-if-vl-50-stack)#member port-channel 20
Dell(conf-if-vl-50-stack)#
Dell#show running-config interface vlan 50
!
interface Vlan 50
vlan-stack compatible
member Port-channel 10,20
shutdown
Dell#
Verify that the Port Channels used in the VLT Domain are Assigned to the VLAN-Stack VLAN
Dell#show vlan id 50
Codes: * - Default VLAN, G - GVRP VLANs, R - Remote Port Mirroring VLANs, P -
Primary, C - Community, I - Isolated
O - Openflow
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
o - OpenFlow untagged, O - OpenFlow tagged
G - GVRP tagged, M - Vlan-stack
i - Internal untagged, I - Internal tagged, v - VLT untagged, V - VLT tagged
NUM Status Description Q Ports
50 Active M Po10(Te 1/8)
M Po20(Te 1/20)
V Po1(Te 1/30-32)
Dell#
IPv6 Peer Routing in VLT Domains Overview
Peer routing for IPv6 packets in VLT domains is supported on the S4810, S4820T, S6000, Z9000, and
MXL platforms.
Virtual Link Trunking (VLT) is a mechanism that enables the physical links between two devices that are
called VLT nodes or peers, and within a VLT domain, to be considered as a single logical link to external
devices that are connected using LAG bundles to both the VLT peers. This capability enables redundancy
without the implementation of Spanning Tree Protocol (STP), thereby providing a loop-free network with
optimal bandwidth utilization.
1050
Virtual Link Trunking (VLT)