Users Guide

enable stack-unit transceiver
Enable the 10GBase-T optical port that is reset due to high temperature to normal mode.
Syntax
enable stack-unit unit-number port port-number transceiver
Parameters
stack-unit unit-
number
Enter the keyword stack-unit then the unit-number for which you want to
enable temperature polling. The range is from 1 to 6.
port port-number Enter the keyword port then the port-number for which you want to enable
temperature polling. The range is from 1 to 48.
Defaults Enabled
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Introduced on the S4048–ON and S5048F-ON.
Usage
Information
This feature is applicable only for 10GBase-T optical ports.
NOTE: It is not supported for stacking ports.
errdisable recovery cause
Enable automatic recovery of an interface from the Err-disabled state.
Syntax
errdisable recovery cause {bpduguard | fefd | maclearnlimit}
To disable the automatic recovery, use the no errdisable recovery cause {bpduguard |
fefd | maclearnlimit} command.
Parameters
bpduguard Enter the keyword bpduguard to enable the timer to recover the interface from
BPDU Guard error.
fefd Enter the keyword fefd to enable the timer to recover the interface from FEFD
error.
maclearnlimit Enter the keyword maclearnlimit to enable the timer to recover the interface
from MAC learning limit error.
Defaults Disabled
Command Modes CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Introduced on the platforms S4048–ON, S6100–ON, Z9100–ON, S4048T-ON,
S3048–ON, S6000, S6010–ON, S5048F-ON, FN-IOM and MXL.
9.13(0.2P2) Introduced on the S3100.
Usage
Information
This command has to be configured before the interface moves to Err-disabled state. If not, the recovery
action is not performed.
Related
Commands
errdisable recovery interval— Configure recovery timer interval for an interface.
Interfaces 679