Administrator Guide

Usage Information Users entering EXEC Privilege mode or any other configured privilege level can access configuration commands.
To protect against unauthorized access, use the enable password command to configure a password for the
enable command at a specific privilege level. If no privilege level is specified, the default is privilege level 15.
NOTE: If you are authorized for the EXEC Privilege mode by your role, you do not need to enter an
enable password.
Related
Commands
• enable password — configures a password for the enable command and to access a privilege level.
enable cpu-clock-monitor
Enables Intel CPU LPC (Low Pin Count) clock-failure monitoring.
Syntax
enable cpu-clock-monitor
To disable this feature, use the no enable cpu-clock-monitor command.
Parameters None
Defaults Enabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.11(2.0P1) Introduced on the C9010, S3048–ON, S6100–ON and Z9100–ON.
Usage Information Enables Intel CPU LPC (Low Pin Count) clock-failure monitoring and issues a warning syslog to the user to take
appropriate action if signal degradation is seen.
enable optic-info-update interval
Enable polling intervals of optical information updates for simple network management protocol (SNMP).
Syntax
enable optic-info-update [interval seconds]
To disable optical power information updates, use the no enable optic-info-update interval
command.
Parameters
interval seconds Enter the keyword interval then the polling interval in seconds. The range is from 120
to 6000 seconds. The default is 300 seconds (5 minutes).
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
96 Control and Monitoring